2024 NIFTYLIFT SD50D 4×4 56’ MAN BOOM LIFT
This was a Demo Unit! It will come with a one year warranty!
2024 NIFTYLIFT SD50D
Powered by: Kubota Diesel
Hours: 60.1
49′ 6” Platform Height / 56’ Work Height / 28’ 6” Horizontal Reach
Hydraulic Outriggers/Stabilizers
4×4
Width: 5’ 3”
Working Width: 14’ 5”
Basket Width: 3’ 7”
Minimum Weight: 5,950lbs
SEE ATTACHED SPEC SHEET IN PHOTOS!
NOT THE MODEL/CONFIGURATION YOU ARE LOOKING FOR?! WE CAN ORDER ANY MODEL YOU’D LIKE INQUIRE FOR MORE INFORMATION!
Low profile sub frame and mounting height
6″ bore x 15″ stroke hoist, standard.
50 deg. Dump angle (10 ton) (13″ high side w/ drive on gate)
6″ x 2″ structural tube frame.
Auto locking body latch w/ ergonomic pull handle.
Warn 15K electric industrial winch w/ tensioner
303 Stainless side rollers pressed over greaseless bronze bearings
303 Stainless rear rollers pressed over DOM steel
with greaseless/replaceable stainless shafts
Stainless steel side guide rails
Exterior mounted body prop
Stainless Steel pump cover
Spacer plates between upper & lower frames minimizes rust contact points
“Winch-in” stop switch
Able to accept other body brands
30′ EIPS 1/2″ cable w/ 4.5 ton swivel hook
Nylon cable roller, self lubricating, for less cable wear
4 button, in cab, control pendant
1/0 GA battery cables w/ 600 amp fuse
PPG cured paint w/ corrosion resistant epoxy primer
Low profile sub frame and mounting height
6″ bore x 15″ stroke hoist, standard.
50 deg. Dump angle (10 ton) (13″ high side w/ drive on gate)
6″ x 2″ structural tube frame.
Auto locking body latch w/ ergonomic pull handle.
Warn 15K electric industrial winch w/ tensioner
303 Stainless side rollers pressed over greaseless bronze bearings
303 Stainless rear rollers pressed over DOM steel
with greaseless/replaceable stainless shafts
Stainless steel side guide rails
Exterior mounted body prop
Stainless Steel pump cover
Spacer plates between upper & lower frames minimizes rust contact points
“Winch-in” stop switch
Able to accept other body brands
30′ EIPS 1/2″ cable w/ 4.5 ton swivel hook
Nylon cable roller, self lubricating, for less cable wear
4 button, in cab, control pendant
1/0 GA battery cables w/ 600 amp fuse
PPG cured paint w/ corrosion resistant epoxy primer
Powered by: (Hybrid) Kubota Diesel Engine & DC Electric Motor w/ Batteries
85′6″ Platform Height / 92′ Work Height / 62’ Horizontal Reach
4×4
Electric Power to the Platform
Non-Marking tires
40% Gradeability
150° Jib Boom
180° Rotating Basket
Transport Length: 23’ 11”
Basket Width: 7’ 10”
Basket Working load: 620lbs
Minimum Weight: 31,880lbs
Overall Dimensions: (LxWxH) 30’5″x8’2″x8′10″
*1yr Factory Warranty (Parts & Labor) & 5yr Structural Warranty — Optional 2yr, 3yr & 4yr Warranties Available*
SEE ATTACHED SPEC SHEET IN PHOTOS!
NOT THE MODEL/CONFIGURATION YOU ARE LOOKING FOR?! WE CAN ORDER ANY MODEL YOU’D LIKE INQUIRE FOR MORE INFORMATION!
Powered by: Kubota Diesel Engine
62′ Platform Height / 68’6” Work Height / 42’8″ Horizontal Reach
4×4
Electric Power to the Platform
Non-Marking tires
45% Gradeability
150° Jib Boom
160° Rotating Basket
Transport Length: 17’ 11”
Basket Width: 5’ 11”
Equipped with the Tough Cage Basket
Basket Working load: 550lbs
Minimum Weight: 14,790lbs
Overall Dimensions: (LxWxH) 22’x7’5″x7′2″
*1yr Factory Warranty (Parts & Labor) & 5yr Structural Warranty — Optional 2yr, 3yr & 4yr Warranties Available*
SEE ATTACHED SPEC SHEET IN PHOTOS!
NOT THE MODEL/CONFIGURATION YOU ARE LOOKING FOR?! WE CAN ORDER ANY MODEL YOU’D LIKE INQUIRE FOR MORE INFORMATION!
2025 Used Down 2 Earth DTE7610G29 – Single Axle Utility Tube Steel 6’4”x10’ Trailer
Stock#: UPTE6168
•6’4”x10’ Deck
•Dexter 3,500lb E-Z Lube Axle
•GVWR: 1,359KG (2,990lbs)
•Payload: 1,970LBS
•2” Coupler
•Fold-Up Jack
•48” Gate
•Treated 2” x 8” Floor
•4x Tie Down Rings
•Spare Tire Mount
•205/75R/15 Tires
•DOT Tape
•All LED Lighting
•NATM Compliant!
2018 Heat King IDF1000 Indirect Fired Mobile Construction Heater
2018 Heat King IDF1000
Powered by Yanmar Diesel
Diesel Fired
Engine Hours: 5,852
Burner Hours: 3,888
IDF Heater (Indirect Fired Heater)
1,000,000 BTU
Air Flow: Max 9000CFM
Up to 40 Hours or runtime on a single fuel fill
4x 16” Outlets
Self-Contained and fully enclosed
Pintle Hitch
Unit is serviced and ready to go to work!
2024 NIFTYLIFT SD50D 4×4 56’ MAN BOOM LIFT
This was a Demo Unit! It will come with a one year warranty!
2024 NIFTYLIFT SD50D
Powered by: Kubota Diesel
Hours: 61.8
49′ 6” Platform Height / 56’ Work Height / 28’ 6” Horizontal Reach
Hydraulic Outriggers/Stabilizers
4×4
Width: 5’ 3”
Working Width: 14’ 5”
Basket Width: 3’ 7”
Minimum Weight: 5,950lbs
SEE ATTACHED SPEC SHEET IN PHOTOS!
NOT THE MODEL/CONFIGURATION YOU ARE LOOKING FOR?! WE CAN ORDER ANY MODEL YOU’D LIKE INQUIRE FOR MORE INFORMATION!
2020 Freightliner M2 106 Altec Material Handler Bucket Truck
2020 Freightliner M2 106
Cummins 6.7L Turbo Diesel
Allison Automatic Transmission
Odometer Reads: 72,515 Miles
4×2
WB: 190”
GVWR: 33,000lbs
Air Brakes
Trailer Air Hook Up
Pintle Hitch
Exhaust Brake
Locking Rear Diff
Bench Seat
A/C + Heat
AM/FM Radio
14′ Utility Service Bed w/ Storage Compartments
Strobe Lights
Good Tires all around!
Equipped with the following:
Altec AM55E Boom
56’ Platform Height / 61’ Working Height
-Rear Mounted Boom
Two Man Bucket
-Rated for 600lbs
Hydraulic Tool Circuit at platform
Material Handling System
-Rated for 2,000lbs
Boom is insulated for 46kv
Hydraulic Platform Rotation/Tilt
Continuous Rotation
4 Outriggers
Upper and Lower Controls
-Lever Lower Controls
-Pistol Grip Upper Controls
Emergency Stop Valve at Upper and Lower Control Station
Altec boom was ANSI/Dielectrically tested!
Truck was Serviced, Greased and Vehicle Inspected!
WE OFFER CUSTOMIZABLE AFTERMARKET WARRANTIES FOR 2015+ INQUIRE FOR MORE DETAILS!
2017 Ford F550XL Altec Utility Bucket Truck
2017 Ford F550XL
6.7L Powerstroke Turbo Diesel
Automatic Transmission
Odometer reads: 80,749 Miles
4×2
A/C and Heat
AM/FM radio
Hydraulic Brakes
Bench Seat
18,000 GVWR
Pintle Hitch
9′ Utility Storage Box + 3′ 6″ Rear Bumper Platform_
-w/ Material Storage Bins
Strobe Light
Good tires all around!
Equipped with the following:
Altec AT40-G Boom
40’ Platform Height / 45’ Working Height
-Center Mounted Boom
Man a Half Bucket
-Rated for 400lbs
Hydraulic Platform Tilt
Hydraulic Platform Rotation
Hydraulic Tool outlets at bucket_
Boom is insulated and rated for 46KV
Continuous Rotation
Upper and Lower Controls
-Lever Lowers
-Pistol Grip Uppers
Emergency Stop Valve at upper and lower controls
Altec boom will be ANSI/Dielectrically tested before sold!
Truck will be Serviced, Greased and Vehicle Inspected before sold!
Recent Comments